I think 1kg spools are too much, I want to experiment with ALL THE COLORS… But few manufacturers offer 250g, and they are sometimes twice the cost by weight.
I think 1kg spools are too much, I want to experiment with ALL THE COLORS… But few manufacturers offer 250g, and they are sometimes twice the cost by weight.
Agreed, large spools are too much if you want to play around with all the colors. I have a box of old filament, each spool in plastic with a dry packet and the whole box with a couple of bags of drying stuff and a good seal on the top. But after getting a spool out to use recently (spool about 2 year old) and it printed like shit. I tried putting it in a dryer, but it didn’t help. So I tried more of these spools and they almost all seem to have gone bad.
Such a shame, I should have bought smaller spools, but they are harder to get and often more expensive.
Same. I go through periods of printing a lot then getting busy and not touching it for months. I’ve noticed my PLA and PLA+ get really brittle as they age even when stored in a dry box and drying again before use.
I can usually get it to print but I have to be gentle with it.