Slide under the midpoint with a battery powered angle grinder or a sawzall and cut 3/4 of the way through one side of the frame. Then you just let physics do the rest when they hit a good hard bump.
Xanthan gum and muriatic acid will make a nice corrosive paste that might do the trick if you’re into edging with your sabotage.
Nitrile gloves, thicker the better. It will break them down but it will take a while. The fumes are chlorine gas, but aren’t that bad if you’re outside. What you really have to watch out for is getting it in your eyes, wear goggles.
Baking soda will neutralize it, so you might want a gallon of water and some baking soda on hand. It will burn your skin if you leave it on you, but it takes a minute and you have time to just wash it off.
Too much truck, not enough dick, as they say.
Slide under the midpoint with a battery powered angle grinder or a sawzall and cut 3/4 of the way through one side of the frame. Then you just let physics do the rest when they hit a good hard bump.
Xanthan gum and muriatic acid will make a nice corrosive paste that might do the trick if you’re into edging with your sabotage.
Sawing that thing without being caught is hard. So, about that xanthan and muriatic paste, what kind of gloves should I use for protection?
Nitrile gloves, thicker the better. It will break them down but it will take a while. The fumes are chlorine gas, but aren’t that bad if you’re outside. What you really have to watch out for is getting it in your eyes, wear goggles.
Baking soda will neutralize it, so you might want a gallon of water and some baking soda on hand. It will burn your skin if you leave it on you, but it takes a minute and you have time to just wash it off.
Paint brush would be a good way to apply it.
Nitrile, thickness ½ mm, should last you about an hour.