Automotive relays have built in back emf protection diodes.
Automotive relays have built in back emf protection diodes.
You need to put in a double pole relay. Disconnect the horn from the original switch entirely and connect it to one of the relay poles, connect your circuit to the other.
Or just use a single relay and put the horn and your other load in parallel as long as they both run on 12V.
The horn button gets connected to the coil of the relay.
Relays don’t have resistors necessarily in their coils, but the coil is designed to draw a certain amount of current at a certain voltage. In essence it is a resistor. If it were to pass the full current required to drive a car horn through the coil, it would catch fire.
For all those wondering, it was still crispy when I ate it, and the sauce was delicious. Also those are pickled red onions on the side.
Thanks SatansMaggotyCumFart
Shorting where a capacitor was won’t provide any power, it will most likely cause a short circuit, potentially resulting in sparks and flames.
It looks so much bigger in person.
Deglazing liquid does not have to be acidic, water works fine too, but you aren’t adding any flavor. It’s the action of adding a liquid to a pan that’s above boiling that works all the fond off the bottom of the pan.